Kupite Premium da sakrijete sve reklame
Objave: 3   Posjećeno od: 46 users
26.12.2010 - 23:40
Not sure if this is a bug or just my stupidity. sometimes you will have a stack of subs and marines in the water. lets say 5 marines and 20 subs. since there are so many subs (including some subs that must not have any marines on them), you think you would be able to split them into separate stacks, but i have been unable to do that. the stack is stuck as 1 stack.
Učitavanje...
Učitavanje...
27.12.2010 - 03:44
 Ivan (Admin)
Napisano od lighthauskeeper, 26.12.2010 at 23:40

Not sure if this is a bug or just my stupidity. sometimes you will have a stack of subs and marines in the water. lets say 5 marines and 20 subs. since there are so many subs (including some subs that must not have any marines on them), you think you would be able to split them into separate stacks, but i have been unable to do that. the stack is stuck as 1 stack.

Have you tried splitting marines instead and clicking the 'load' button to move them?
Učitavanje...
Učitavanje...
28.12.2010 - 19:52
Napisano od lighthauskeeper, 26.12.2010 at 23:40

Not sure if this is a bug or just my stupidity. sometimes you will have a stack of subs and marines in the water. lets say 5 marines and 20 subs. since there are so many subs (including some subs that must not have any marines on them), you think you would be able to split them into separate stacks, but i have been unable to do that. the stack is stuck as 1 stack.


I had this problem too, until I realized that the subs were not on the beach.... if you select marines to move and the green arrow doesnt light up, try movin the subs closer to shore (until you get the anchor thingy)
----
~
Učitavanje...
Učitavanje...
atWar

About Us
Contact

Privatnost | Uslovi korištenja | Baneri | Partners

Copyright © 2024 atWar. All rights reserved.

Pridružite nam se

Proširi riječ